← Back to News
Technical Guide

Why products near the frame weaken detection

Why edge passage weakens

A metal detector aperture is not an empty box. The aperture walls, frame and nearby metal structures couple electromagnetically with the search coils. When a product passes close to the aperture edge or frame, disturbance from those metal parts adds to the product signal, making small metal fragments harder to distinguish. This is normal physics once installation and use boundaries are exceeded, not a broken machine.

Isolation and grounding

There are two ways to respond. In use, keep a margin: pass products as close to the centre as practical, match package size to aperture size, and avoid running permanently against the edge. In structure, isolate properly: do not add metal guides, baffles or fasteners inside the aperture, use non-metallic supports where needed, and follow the maker's grounding and equipotential bonding requirements between frame and conveyor to reduce stray current paths.

Buyer and site checks

At purchase, ask what the aperture liner is made of, how frame and coils are isolated, and where the grounding terminals are. On site, check regularly that grounding wires are tight and that no metal parts have been added inside the aperture. Control these points and the rated sensitivity has a chance to show up on the real line.

FAQ

Is reduced sensitivity near the edge a machine fault

Usually not. When a product passes near the aperture wall and frame, disturbance from metal parts adds to the product signal and small metal is harder to distinguish. Check use boundaries and grounding first, then decide whether service is needed.

What aperture details should buyers ask about

Ask about the aperture liner material, how the frame is isolated from the coils, where grounding terminals are, and whether metal parts may be added inside the aperture. These details shape how the unit performs on a real line.