← Back to News
Technical Guide

A taller aperture quietly lowers sensitivity

Bigger opening, weaker field

When buying a metal detector, many teams choose the largest aperture they can get, reasoning that products will always fit and future formats will be easier. But aperture size and sensitivity trade off against each other: the larger the opening, the farther apart the transmit and receive coils, and the weaker the effective field inside the passage. A given piece of metal then produces a smaller signal change, so the machine may still alarm, but only for larger contaminants.

Measure product, then aperture

A sound approach is to measure the product first and size the aperture second. Take the maximum height of the product as it passes and add a moderate margin; there is no need to enlarge the whole line's aperture for an occasional tall item. If formats really do vary widely, consider sizing for the main format and routing exceptional tall items separately, or discuss liners and split structures with the manufacturer to narrow the effective detection zone while keeping clearance.

Fix product position too

One point is easily overlooked: once the aperture is fixed, where the product sits inside it matters. A product running close to the bottom of the passage and one passing higher up do not behave the same, so the relationship between belt surface, support height and aperture should be fixed at acceptance. Tell the supplier product height, pack format and the metal size you need to catch, and let them recommend the opening, rather than judging only by what will fit through.

end

FAQ

Is a larger aperture better for future product changes?

It adds clearance, but a larger opening weakens the effective field between coils, so a given metal produces a smaller signal. Sizing for the main product with a moderate margin, and handling tall items separately, is usually more practical.

Does product position inside the aperture affect results?

Yes. Passing close to the bottom of the passage and passing higher up do not give the same result. Fix the relationship between belt surface, support height and aperture at acceptance so the same product is tested consistently.