← Back to News
Technical Guide

Does stacking products higher improve detection

Height affects field uniformity

When choosing a metal detector or needle detector, buyers often focus on aperture width and opening size but overlook the actual stacking height of products on the conveyor. The aperture height determines where the product sits relative to the upper and lower coils. If products are stacked too high and sit close to the top of the aperture, or if the stack height varies from item to item, the magnetic field strength felt by different parts of the product is not uniform, and positions near the edges are more likely to show a weaker response.

Give stack height at selection

This effect is more noticeable when detecting small metal contaminants. The sensitivity quoted for a machine is usually obtained under specific test conditions, while in real production the product shape and stacking pattern change those conditions. Buyers should therefore give the manufacturer the maximum stack height, single-item height and placement method, so the manufacturer can confirm whether the aperture height leaves reasonable margin. Too little margin compresses the effective detection zone, while too much margin may affect the response to small contaminants.

Recheck height after changeover

The same issue needs managing in daily use. When changing products on the same machine, confirm that the new product height and stacking pattern do not exceed the assumptions made at selection. For products that must pass stacked, keep the height stable through placement guides or a limit on the number of layers. Treating aperture height as a process parameter that must match the product is more useful for consistent results than simply choosing a larger opening.

FAQ

If I give the product width, do I still need to give the height?

Yes. Aperture height determines the product position relative to the upper and lower detection zones. Width alone cannot show whether a stacked product sits close to the top of the aperture, so provide single-item height, maximum stack height and placement method.

How can I reduce the effect of height variation when products pass stacked?

Use placement guides or limit the number of stacked layers to keep the passing height stable, and when changing products, recheck that the new height and stacking pattern still fall within the assumptions made at selection.