← Back to News
Technical Guide

Belt tracking drift affects detection

Drift shifts product position

Many plants focus on sensitivity settings and test samples but overlook a condition that changes every day: whether the conveyor belt runs straight. When the belt drifts slightly, the position of the product passing through the detection aperture changes. A product near the aperture edge or off centre does not couple with the field in the same way as one passing through the middle. On wide apertures or with small products, this can make results inconsistent and look like equipment instability.

Friction and vibration

Drift also brings side effects. A belt rubbing against the frame or side plates creates extra friction and vibration, which the detection coil can pick up. Worn, frayed or warped belt edges passing the probe area may also cause signal fluctuation. Drift often comes with uneven tension, so belt speed varies slightly and the actual dwell time of the product in the aperture changes, adding further uncertainty to results.

Check empty, adjust in steps

To check, run the belt empty and watch whether it stays stable between the drive and tail rollers, then inspect idlers, tracking rollers and guide edges. Adjust in small steps, and after each adjustment run both an empty pass and a pass with test samples, confirming no false rejects or abnormal alarms before returning to production. Including belt tracking in daily checks is easier than tracing a missed detection afterwards.

FAQ

Can belt drift directly cause missed detections?

Drift alone is not the only cause of missed detection, but it changes the position and attitude of the product in the aperture and brings friction, vibration and speed variation, making results unstable. When results fluctuate, check belt tracking as well.

What should I watch when adjusting belt tracking?

Run the belt empty first and observe its position, then inspect idlers, tracking rollers and guide edges. Adjust in small steps, and after each change verify with an empty pass and a pass with test samples, confirming no false rejects or abnormal alarms before resuming production.